Bulb Required 12V 21/5W.Just two screws to remove,Twist the Light Unit Off carefully so as not to damage the cables.Optionally disconnect cable by pressing t Once that comes down, there is going to be a metal frame that follows. Take note of how this attaches and save it. 10. To get the headliner out of the car, if you have a hatch you can try pulling it out that way. If not, the front passenger side will do. Move and squirm your way till the headliner is at a 45' angle. Where the hinge part is underneath, you can unscrew the whole plastic arm rest off its metal support where it slides forward and back, if that makes sense, you should be left with the metal frame when the plastic rest comes away. It was a while ago when I did it though, remember it being a touch fiddly. andip85 said: What did you have to unscrew? FORD FOCUS MK3 REAR TAIL LIGHT REMOVAL REPLACEMENT 2012 2013 2014 2015 2016 Check Out Our Website: http://mechaniclifestyle.com OUR MAIN CHANNEL: http://bit 2. From inside the luggagecompartment remove the wing nutof the rear light assembly cover. 3. Using a Phillips screwdriverremove the screw. The lamp is stillretained by a spring loaded clip.Remove by gently pulling out thelight housing. 4. Turn the bulb socket counterclockwise as far as possible and pull itout. 5. Pull the bulb straight out of Unplugged the cable loom from the old unit. Checked the units were same size and the plugs were the same. Attached the new unit and tested the lights, dimmer and levellers. Pushed the new unit into place (takes a bit of a push). Relocated the ODB port into the trim and refitted to dash. Pry it up a bit and you'll find the screws and whatnot to get it off completely. - Remove the same colored plastic that goes around the gauges on the driver side - Again pry it up and remove any screws to get it free. - Lift up the console door in between the seats, and pry up on the center console. To fully release this piece, the boot must be Remove the aerial from the base. remove the interior light cluster then you will see the receiver block with a torx screw. undo the torx screw and the will release the aerial base. clean the roof and simply fit the new base. you will need to reconfigure the sat nav aftwards. LoPelS.